TV One C2-7000 Series, Руководство пользователя

Страница: 89 / 120

C2-7000 S
ERIES
O
PERATION
M
ANUAL
83
12.3 Basic setup of the two projectors
The above diagram shows how the two projects should be placed to create a
wider than normal image. The amount by which they overlap is very
important, as this will also relate to the zooming values to be used for each of
the CORIO®2 scaling engines.
Zooming is required because each projector is showing slightly more than half
of the projected image, and thus each channel needs to be zoomed into a
different area of the original source picture.
At this point, it is only necessary to place the projector roughly where you
would like them to be, with around 15% overlap horizontally. If your projectors
are already fixed into position, check that there is around 10% to 20% overlap,
or edge-blending will not be possible.
You must also ensure that both projects are in focus with the same zoom
settings (if your projector has this). It is often worth doing a ‘factory reset’ on
them to ensure that no other settings (such as gamma correction or tilt) are
active.
12.4 Connections to the scaler(s) and projectors
For CORIO®2 units with two scaling engines (such as the C2-7000 series),
use outputs 1 and 2 to connect to the left and right projectors respectively.
If two single-channel scalers (such as the C2-1000 or C2-2000 series) are
used, then connector unit ‘1’ to the left-most projector, and unit ‘2’ to your
right-most projector. Hereafter, we’ll talk about Output 1 and Output 2 as
referring to unit 1’s output and unit 2’s output.
Basic video projector setup showing overlap.