Tuttnauer 5075 HSG, Руководство по эксплуатации и обслуживанию

Страница: 28 / 34

Page 26
8.4. Starting a cycle
1. Load the autoclave properly (see 7)
2. Use the UP/DOWN keys to select the program to run.
3. If the autoclave is equipped with a printer verify that a paper roll is inserted in
the printer. If not - insert as shown in 4.1.
Note: The program can only be changed when the door is open.
4. Close the door.
a. Move the door handle (1) from position "unlocked" (3) to position "locked" (2).
b. The open door symbol is replaced by the message "System Ready".
8.5. Ending the cycle. Unloading
When the cycle has ended successfully (including the user pressing the START/STOP key
after the sterilization stage has finished) the message “Cycle Ended” is displayed.
In the event of a failure, after completing the sterilization stage, the message "Cycle Ended"
and the relevant failure message is displayed on the screen.
Pressing the START/STOP key will clear the "Cycle Ended" message or any error message
and unlock the door.
1. Verify that there is no pressure in the chamber, according to the reading on
the display, and that “System Ready” is displayed. Only then may the door be
opened.
2. To release the door locking at the end of operation, press the UP key. The
same applies at power up after fail. Unlock the door properly: see Error!
Reference source not found. . Open the door the minimum required to let
the residual steam to escape from the chamber. Only after there is no vapor,
open the door widely.
Warning!
To avoid severe injuries from hot steam when opening the door: it is
strictly forbidden to lean on the autoclave. It is strictly forbidden to place
your hand or any part of your body over the door.
3. On completion of the cycle, the load shall be visually inspected to ascertain
that the load is dry, and that sterilization indicators have made the required
color change.
4. At the end of each working day close the main water valve.
Warnings:
The sterility of the instruments processed in unwrapped
cycles cannot be maintained if exposed to non-sterile
environment.
Don’t touch the strainer’s cover, mounted on the exhaust line,
3
1
2