Tuttnauer 2840 ELG-D, Руководство по эксплуатации и обслуживанию

Страница: 66 / 95

Page 64
 Wear heat-resistant gloves or use the tray handle to remove the load
from the autoclave

On completion of the cycle, the load shall be visually inspected to
ascertain that the load is dry, and that sterilization indicators have
made the required color change.
10.6 Stopping the process and canceling the ERROR
message

It is possible to stop the program while the autoclave is operating.
Pressing the START/STOP key at any stage of the process stops the
operation. If the cycle was aborted before completing the sterilization
stage, it will leave the load unsterilized.

At the end of the aborted process (before completing the sterilization
stage), "Cycle Failed" message, error message and a warning
symbol are displayed on the screen. Refer to "Displayed Error
Messages/Symbols".

Pressing the START/STOP key cancels the displayed message and
enables opening the door.
If the door is not opened, the vacuum pump will stop automatically
after 30 minutes (ELPV model only)..
Warning
The load has not completed a sterilization cycle, therefore it is
not sterile. Handle it as contaminated load.
10.7 Cycle by Clock mode (Start Cycle by Clock)

This mode enables the operator to define the time of the beginning of
the cycle. The maximum possible delay is 24 hours.
10.8 Moving the Autoclave
1. Disconnect the power supply cord.
2. Disconnect the water and drain hoses.
3. Disconnect the compressed air hoses (if applicable).
4. Drain the water from the chamber.
Caution!
Before moving the autoclave, verify that the electrical, air and
water connections have been disconnected, and there is no
pressure in the chamber.
Do not drop this device!