Tulikivi HETTA, Руководство по эксплуатации

Страница: 9 / 24

9
Cleaning and maintenance
DOOR AND DOOR GLASS
Never use a scrubbing brush or anything else abrasive to clean
the door glass. Clean it with glass cleaning fl uid or ash and
moistened kitchen paper towels. Clean the door glass only
when it is cold. Regularly check the tightness of the seals
between the door frame, body, and glass. If the door glass
becomes constantly sooty, the reason may be that you are
using moist wood.
CLEANING THE SOAPSTONE SURFACE
The soapstone surface of Tulikivi’s fi replaces can be washed
and cleaned with ordinary household cleansers. For remov-
ing tough stains on smooth surfaces, we recommend either a
stain remover such as Tulikivi cleanser, and for rough surfaces,
a brass brush (not a brassed steel brush).
FREESTANDING INSTALLATION
Standing resedential freestanding installation require 6”
(152mm) diameter, minimum 24 MSG black or 25 MSG
blued steel connector, with listed (type UL 103 HT) factory-
built chimney, suitable for use with solid fuels or masonry
chimney. (See for more detailed information about installation
requirements, table and drawings on the next page)
CARING FOR WOODEN SURFACES (KIISA)
A damp cleaning cloth is suitable for ordinary wiping of waxed
wooden surfaces. When necessary, a mild, neutral cleaning
solution – such as ordinary dishwashing soap – can be used.
FIREPROOF PANELS IN THE FIREBOX
Small fractures in the fireproof panels will not affect the
proper functioning of the fi replace. However, a panel must
be changed if it is broken or badly chipped.
Note: When a fi re is burning, the cast iron door frame and
glass do get very hot; avoid contact with these areas.
If the chimney connector pipe glows red, you are overfiring.
One of the chief advantages of a Tulikivi fireplace is that the
fi re is out while you sleep – but the heat is on. Do not create
a safety hazard by burning a fire – especially in a slowdown
mode – while you sleep. It is extremely unlikely if you are
using your Tulikivi correctly that you will have any creosote
buildup. However, it is a good idea to contact your local fire
department for information on how to handle a chimney fire
and have a plan on hand for emergencies.
CREOSOTE – FORMATION AND NEED FOR REMOVAL
When wood is burned slowly, it produces tar creosote and
other organic vapors, which combine with expelled moisture
to form creosote. The creosote vapors condense in the rela-
tively cool chimney fl ue of a slow-burning fire. As a result,
creosote residue accumulates on the fl ue lining. When ignited
this creosote makes an extremely hot fire. The chimney con-
nector and chimney should be inspected at least once ev-
ery two months during the heating season to determine if a
creosote buildup has occured. If creosote has accumulated,
it should be removed to reduce the risk of a chimney fire.
WOOD AMOUNT
Max. amount of wood to be burnt, Ignition load,
lbs/h lbs
HETTA 4 1 - 2
KIISA 4 1 - 2
ZEVIO 4 1 - 2
4. 5.
COMBUSTION AIR CONTROL SETTINGS
Combustion phase Air control lever setting
Ignition Position
(Max 15 min.)
Burning Position
Coals Position