TSI Incorporated 8525, Руководство по эксплуатации и обслуживанию

Страница: 25 / 67

Setting Up
17
3. Select Instrument Setup, Communications in T
RAK
P
RO
™
software. The following dialog is displayed:
Figure 2-9: Instrument Setup, Communications Dialog Box
4. Select the correct serial port (such as, COM1); then select Test . The
software will verify that you have set up the communications port
correctly and that it is communicating with the P-T
RAK
®
particle
counter. The system displays an information message indicating
whether it was able to establish communications.
5. As an alternate, you may select Find Port , to have T
RAK
P
RO
™
software search the available COM ports, looking for an attached
P-T
RAK
®
particle counter.
6. Select OK to accept the setup, or Cancel to discard the changes.
Connecting the Optional Portable Printer
To connect the portable printer to the P-T
RAK
® particle counter, do the
following:
1. Ensure that the P-T
RAK
® particle counter and printer are off.
2. Locate the printer interface cable and connect the 9-pin end labeled
PRINTER to the printer and the other end to the communications port
on the P-T
RAK
® particle counter.
3. Turn on the P-T
RAK
® particle counter; then turn on the printer.
Note : Always turn on the P-T
RAK
® particle counter before turning on the
printer. If the printer prints question marks (??????), asterisks
(******), or random characters, reset it by turning it off and then
on again. If necessary, refer to the Portable Printer Manual.