Trumpf KF023, Руководство оператора

Страница: 41 / 176

Assembly and installation
Commissioning of the focusing optics:
■ is done by a service engineer of TRUMPF during the com-
missioning of a laser device, if the focusing optics is deliv-
ered together with a laser device.
■ is done by the user after start-up of an existing laser device,
if you purchased the focusing optics afterwards.
The following conditions must be fulfilled:
■ All guards must be installed and ready for operation.
■ Suitable laser safety glasses must be at hand.
■ If additional media are required, they must be provided:
−
Shielding gas
− Compressed air
− Exhaust system
− Cutting gas
■ There must be enough samples for the commissioning proce-
dure. A suitable workpiece holder for the samples must be
provided.
In case of a subsequent start-up, the conditions for operating
the focusing optics have to be established in the laser device:
■ Installation of the Interface Intelligent Optics (IIO).
■ Installation of an additional supply unit with the supply vol-
tages required by the focusing optics (depending on the
existing laser device).
■ Installation of units for cooling water supply to the focusing
optics (cooling water distributor, hoses, etc.).
12-29-01-A1-CRen 2022-03 Assembly and installation
2 ‐ 3