Trumpf KF023, Руководство оператора

Страница: 128 / 176

If the processing requires it, a change of the working distance in
Z or the focus position in X and Y must be realized via an exter-
nal adjustment (robot, linear axis, etc.).
1. Select the operating mode for the laser and the parameters
as follows:
Pulsed laser device:
− Square pulse, number of pulses: 1
− Pulse power: 700 Watt
− Pulse duration: 1 ms
CW laser device:
− Power: 300 W
− Duration: 10 ms
2. Start the PFO editor and the function wizard as described in
chapter "Operation".
3. Select "Teach".
The teach function is active.
4. Select Zero point .
The scanner mirrors of the focusing optics are positioned
such that the laser beam hits the center of the processing
field.
5. Adjust the focusing optics to the working distance a (see
dimensional drawing) above the surface of the test sheet.
The working distance depends on the focal length of the
lens used (see data sheet of your focusing optics).
Adjusting working distance a to workpiece Fig. 112282
4 ‐ 16
Focal position 2022-03 12-29-01-A1-CRen
Setting the focal position