Trumpf KF023, Руководство оператора

Страница: 126 / 176

2
3
4
1
1 Cap 3 Foot
2 Plate 4 Springy contact pin
Teach function Fig.
SE-15081
7. If the horizontal alignment of the focusing optics relative to
the working surface is not ensured (e.g. when used on a
robot):
−
Switch off the line lasers of the two teach modules with
the external control unit.
− Place the teach function in the middle of the light spot of
pilot light on the workpiece.
− Change the focusing optics position until the pilot light
hits the center of the plate of the teach function.
8. Repeat steps 4 to 6 until the focusing optics position and
working distance are set correctly.
Position and working distance of the focusing optics are set for
the teach point on the workpiece.
4 ‐ 14
Setting the working distance using the teach
modules (option) 2022-03 12-29-01-A1-CRen