Triumph Tiger 1200 XR Series, Руководство пользователя

Страница: 28 / 226

Instruments
28
Triumph Semi Active Suspension
(TSAS) Warning Light
When the ignition is switched on
the warning light will illuminate for
1.5 seconds and then go out.
The warning light has two modes:
Calibration
The TSAS system will recalibrate
adjustment motors under the following
conditions:
• If the battery has been
disconnected for any reason.
• If a fault occurs with the TSAS
system during normal operation.
The warning light will flash twice every
second during system recalibration, and
a message will be shown in the display.
During recalibration the motorcycle
must remain stationary. Riding the
motorcycle will cause the recalibration
to be stopped and the warning light to
remain lit.
Fault
If the warning light illuminates
continuously or at any other time it
indicates one of the following:
• A system recalibration has been
interrupted. Allow the system to
recalibrate.
• A fault has occurred with the
system that requires investigation.
Warning messages will be shown in
the display. Allow the system to
recalibrate. If the fault is still
present after recalibration, contact
an authorized Triumph dealer as
soon as possible to have the fault
checked and rectified.
Full details of the Triumph Semi Active
Suspension (TSAS) system and the
system calibration are described
starting on page 108 .
Turn Signals
When the turn signal switch is
turned to the left or right, the indicator
warning light will flash on and off at the
same speed as the turn signals.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched off, until the
hazard warning light switch is pressed
again.
High Beam Button
When the high beam button is
pressed the high beam will be switched
on. Each press of the button will swap
between dip and high beam.
Note:
• If daytime running lights are
installed on the motorcycle, the
high beam button has additional
functionality.