General Information
109
All Models except Tiger 1200 XR
o7:29
12.5
1
9999
02:25
8
6
4
2 0
25.2
F
E
TRIP
mi
mp/h
HH:MM
PM
SET
58
mp/h
10
58
5
12 14
RPM
x1000
1
2
3
1.
Cruise control symbol
2.
Cruise control set indicator
3.
Cruise control set speed
The cruise control system will maintain
the set speed until:
• The set speed is adjusted as
described on page 109.
• Cruise control is deactivated as
described on page 109.
Adjusting the Set Speed While in
Cruise Control
To adjust the set speed while in cruise
control, press and release the:
• RES/+ button to increase the speed
• SET/- button to decrease the
speed.
Each press of the buttons will adjust
the speed by 1 mph or 1 km/h. If the
buttons
are
held,
the
speed
continuously increases or decreases in
single digit increments.
Stop pressing the adjust button when
the desired speed is shown in the
display.
Note:
•
The cruise control set speed display
will flash until the new set speed
has been achieved.
•
If riding up a steep incline and
cruise control is unable to maintain
the set speed, the cruise control set
speed display will flash until the
motorcycle has regained the set
speed.
An alternative way to increase the
speed in cruise control is to accelerate
to the desired speed using the throttle
grip and then press the SET/- button.
Deactivating Cruise Control
The cruise control can be deactivated
by one of the following methods:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the
throttle for more than 60 seconds.
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will still
be shown in the display screen,
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed as described on page 110,
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.