Cleaning And Storage
215
Preparation for Washing
Before washing, precautions must be
taken to keep water off the following
places.
Rear opening of the exhausts: Cover
with a plastic bag secured with rubber
bands.
Clutch and brake levers, switch housings
on the handlebar: Cover with plastic
bags.
Ignition switch and steering lock: Cover
the keyhole with tape.
Remove any items of jewellery such as
rings, watches, zips or belt buckles,
which may scratch or otherwise damage
painted or polished surfaces.
Use separate cleaning sponges or
cleaning cloths for washing painted/
polished surfaces and chassis areas.
Chassis areas (such as wheels and
under mudguards) will be exposed to
more abrasive road grime and dust,
which may then scratch painted or
polished surfaces, if the same sponge or
cleaning cloths are used.
Where to be Careful
Caution
Do not spray any water at all near the
air intake duct. The air intake duct is
normally located under the rider’s seat,
under the fuel tank or near the
steering head. Any water sprayed in
this area could enter the airbox and
engine, causing damage to both items.
Caution
Use of high pressure spray washers is
not
recommended.
When
using
pressure washers, water may be
forced
into
bearings
and
other
components causing premature wear
from corrosion and loss of lubrication.
Avoid spraying water with any great
force near the following places:
• Instruments;
• Brake cylinders and brake calipers;
• Under the fuel tank;
• Air intake duct;
• Headstock bearings;
• Wheel bearings.
Note:
•
Use of soaps that are highly
alkaline will leave a residue on
painted surfaces, and may also
cause water spotting. Always use a
low alkaline soap to aid the cleaning
process.
