General Information
126
To remove the rider’s seat:
• Remove the passenger seat (see
page 124).
• Grasp the rider’s seat on either
side, and slide it rearwards and
upwards.
• If equipped with heated seats,
disconnect
the
heated
seat’s
electrical connector for complete
removal from the motorcycle.
To refit the seat:
• Reconnect
the
heated
seat’s
electrical connector (if equipped).
• Engage the seat's front rail into the
bracket at the rear of the fuel tank
and lower the rear rail into the rear
brackets.
• Push down firmly on the rear of the
seat.
• Refit the passenger seat (see page
124).
Rider’s Seat Height Adjustment
Warning
Always adjust both seat height
adjusters.
Adjusting only one height adjuster
may prevent correct fitment of the
seat.
Riding
the
motorcycle
with
an
incorrectly fitted seat may cause loss
of motorcycle control and an accident.
Warning
After adjusting the seat, operate the
motorcycle in an area free from traffic
to gain familiarity with the new seat
position.
Riding the motorcycle with the seat in
an unfamiliar position may cause loss
of motorcycle control and an accident.
4
4
2
5
3
1
chdi_2
1.
Rider’s seat
2.
Front height adjuster
3.
Rear height adjuster
4.
Low seat height position (front shown)
5.
High seat height position (front shown)
The rider’s seat is adjustable for height
by approximately 20
mm.
To adjust the rider’s seat:
• Remove the rider’s seat (see page
125).
• Reposition
both
seat
height
adjusters to the higher or lower
position as required. Make sure
that both adjuster rails are fully
engaged in their brackets on the
seat.
• Refit the rider’s seat (see page 125).
