Triton RL5000, Руководство по обслуживанию

Страница: 97 / 173

80
RL5000 S
ERIES
XS
CALE AND
X2 A
UTOMATED
T
ELLER
M
ACHINES
S
ERVICE
M
ANUAL
Section 3
4. Perform this step for XScale confi gurations, otherwise, go to step 6. Refer to
Figure 3-50. Connect the low paper/feed paper feed cable to the low paper/
manual paper feed PCB.
5. Perform this step for XScale confi gurations, otherwise, go to step 6. Refer to
Figure 3-68. Connect the presenter communication and power cable to the
presenter PCB.
6. Push the AC pow er ON/OFF switch to the ON(I) po si tion.
7. Close and lock the control pan el.
8. Verify that the ATM op er ates cor rect ly before plac ing it into ser vice.
R
EPLACING THE
P
RESENTER
A
SSEMBLY
R
EMOVING THE
P
RESENTER
A
SSEMBLY
1. Follow the steps for R
EMOVING THE
P
RINTER
/T
RANSPORT
A
SSEMBLY
from the con-
trol panel.
2. Refer to Figure 3-70. Place the printer/transport assembly on a clean work
surface with the backside facing up to access the printer assembly support
bracket and presenter PCB.
3. Refer to Figure 3-70. Remove the two (2) Torx head screws that secure the
presenter assembly to the printer assembly. (They can be accessed through
the openings in the upper left and right corners of the printer assembly sup-
port bracket.)
Torx screws
Figure 3-70. Torx
mounting screws for
the presenter
Ground Wire
Brass standoff
Figure 3-71. Location
of the brass standoff
and ground wire
Support Bracket
Presenter
Printer Assembly
Figure 3-72. Components (printer assy,
presenter, and support bracket) that
make up the printer/transport assy