TX6000 Series Operation Manual Ver1.4
83
Command syntax:
<value>
StepDELay MIN
MAX
Where,
<value> NR1, NR2 or NR3 data format, 0-60s with the resolution of 1mS.
MIN Set the delay time as 0s.
MAX Set the delay time as 60s.
For example: WrtCmd(“FUNC:SDEL 5S”) Set the delay time as 5s.
Query syntax: FUNC:SDEL?
Return format: <NR3><NL^END>
7.1.9
LIST subsystem commands
The LIST subsystem commands are mainly used to set the list sweep function,
sweep points, sweep mode, sweep limits.
Command tree:
LIST :FREQuency <sweep point>[,<sweep point> *]
:VOLTage <sweep point>[,<sweep point> *]
:CURRent <sweep point>[,<sweep point> *]
:BIAS :VOLTage <sweep point>[,<sweep point> *]
:CURRent <sweep point>[,<sweep point> *]
:MODE SEQuence
STEPped
:BAND<n> A[,<low limit n>,<high limit n>]
B
OFF
CLEar
The LIST:FREQuency command is used to clear the original sweep points and set
the frequencies of the sweep points. The LIST:FREQuency? query returns the
current frequency of each sweep point.
Command syntax: LIST:FREQuency<value>[,<value>*]
NOTE: * part means 201 sweep points at most can be set.
Where,
<value> is NR1, NR2 or NR3 data format.
