Trinity Highway REACT 350 II, Руководство по сборке изделия

Страница: 26 / 68

TrinityHighway.com 25 Revision E November 2020
Concrete Backups
1) Rear Cylinder Attachment
Use the top holes of each pair in the Rear Cylinder as a template to locate and drill two (2)
holes, 7/8” [22 mm] diameter x 6” [150 mm] deep into the Concrete Backup (Figure 19). Use
an approved adhesive kit with instructions to secure the 3/4” diameter x 7 1/2” long studs
using instructions included with kit (p. 8). After adhesive has cured, use 3/4” nuts and flat
washers included with the approved adhesive kit to attach the Cylinder Assembly to the
Concrete Backup (Figure 19).
2) Drill and Set Anchors
Use the holes in the Base Track as a template to locate and drill holes, 7/8” [22 mm] diameter
x 6” [150 mm] deep into the concrete pad or roadway surface (Figure 19). Use approved
adhesive kits to attach 3/4” diameter x 7 1/2” long studs using instructions included with kit
(p. 8). After adhesive has cured, use 3/4” flat washers and nuts provided with kit to anchor
Base Track to foundation.
Warning:
All holes in Base Plate must be used to anchor the REACT 350 ® II to
the foundation
.
Figure 19 - Anchoring the System - Concrete Backup
Concrete
Backup
Anchor
Locations
Anchor
Locations
Two (2) Anchor
Locations
Use top hole of
each pair
Anchor
Locations