Manual LCO EXC3/ADV3 OTD | 03-2020 | 1.2 | en
switchDIM
c
50 / 63
Using the switchDIM function
switchDIM is operated by the mains voltage push button.
Procedure:
Synchronising devices
If the devices in a system do not operate synchronously, the devices must be synchronized, i.e. put in the same status (on/off).
Procedure:
Changing the fading time
The default value for the fading time is approx. 3 seconds. It can be changed to approx. 6 seconds.
Procedure:
Switching the LED Driver to automatic mode
In automatic mode the device detects which control signal (DALI, DSI, switchDIM, etc.) is connected and automatically switches to the
corresponding operating mode.
Procedure:
Installation
Wiring variants
There are two options for installing switchDIM: four-pole and five-pole wiring
Switch the device on/off by briefly actuating the push button -or-
_
Dim the device by holding down the push button
_
Hold down the push button for 10 seconds
-> All devices will be synchronized to the same status
-> LEDs will will be set to a uniform light value (approx. 50 %)
-> The fading time will be set to its default value (approx. 3 seconds)
_
Hold down the push button for 20 seconds
-> After 10 seconds: all devices will be synchronized to the same status
-> After 20 seconds: a fading time of approx. 6 seconds will be set
-> LEDs will be set to a uniform light value (approx. 100 %)
_
Press the push button 5 times within 3 seconds
_
