Revision: 0
FlexxPump4 D
User Manual
50
EN-
10.2 Tube lengths
In principle, the recommendation is to install the FP4 D as close as possible to the
consumer (lubrication point). Ideally, this should be done directly at or on the lubrication
point. In cases where this is not possible due to the installation space or for reasons of
reachability or accessibility, tubes can also be used between the FP4 D and the lubrica-
tion point (or distributor).
If the case arises that you cannot mount the FP4 N directly at the lubrication
point, contact the manufacturer to verify your application. The influence of temperature,
the grease used, the hoses and accessories used does not allow a general statement
to be made about the possible hose length on the FP4 N.
10.1 Lubricants
Only use lubricants approved by the manufacturer TriboServ GmbH & Co. KG in the
original cartridges developed and manufactured exclusively for FP4 D.
NOTICE
The lubricant used in each case differs according to the appli-
cation. The respective designation can be found on the label of
the cartridge.
Further information on lubricants, documentation and safety data sheets can be ob-
tained directly from the manufacturer TriboServ GmbH & Co. KG.
