TriangleTube Instinct COMBI 155, Инструкция по установке и обслуживанию

Страница: 48 / 128

36
CHAPTER
6
When selecting and installing a condensate pump,
ensure the pump is approved for use with condens-
ing appliances. The pump should be equipped with
an overflow switch to prevent property damage
from potential condensate spillage.
9. The INSTINCT will typically produce a condensate
that is considered slightly acidic with a pH content
below 4.0. Install a neutralizing filter if required by
authority having jurisdiction.
NOTICE
CHAPTER 6 - INSTALLING VENT/COMBUSTION AIR & CONDENSATE DRAIN
The condensate drain assembly must remain
filled with water. Extended periods of non use or
high temperature operation may allow the water
to evaporate. Periodically check the water level in
the condensate drain assembly and fill with water
as necessary. Failure to keep the condensate drain
assembly full of water can result in substantial
property damage, serious injury, or death.
The drain assembly must remain unobstructed
and allow unrestricted flow of condensate. The
condensate should not be subject to conditions
where freezing could occur. If the condensate is
subjected to freezing or becomes obstructed , it can
leak, resulting in potential water damage to the
boiler and surrounding area.
WARNING
CAUTION
Fig. 22 - Condensate Drain Assembly
FILL PLUG WITH
VACCUM BREAK PORT
SEALS
COMPRESSION
NUT WITH
RUBBER SEAL
Flexible
tubing (or
3/4 PVC/
CPVC Piping
to Drain)
CONDENSATE
DRAIN ASSEMBLY
RETAINING NUT
PLASTIC
BALL
(NOT
SHOWN)