TriangleTube Instinct COMBI 155, Инструкция по установке и обслуживанию

Страница: 35 / 128

23
CHAPTER
4
CHAPTER 4 - BOILER PIPING
Fig. 14 - INSTINCT Combi Near Boiler Piping - Hydraulic Separator
DO NOT install a SMART indirect water heater along with
the INSTINCT Solo in systems with non-oxygen barrier
tubing. Failure to comply will result in premature failure of
the SMART indirect water heater.
The boiler water supply temperature can be maintained
by the INSTINCT Solo, potentially eliminating the need for
a mixing system to achieve the desired temperature if all
zones of heat require the same temperature setpoint.
It is recommended to install a high temperature limit to
ensure that the primary supply temperature does not
exceed the maximum allowable temperature for the radiant
tubing.
The addition of a high temperature limit is important
if the INSTINCT Solo is connected to a domestic hot
water system, which requires a high primary supply
water temperature.
NOTICE
NOTICE
Size the system piping and circulator to provide the
flow needed for the radiant system.
4.8.12 System Piping – Special Application
If the boiler is used in conjunction with a chilled water/
medium system, the boiler and chiller must be piped in
parallel. Install flow/check valves to prevent the chilled
medium from entering the boiler.
If the boiler is used to supply hot water to the heating
coils of an air handler where they may be exposed to
chilled air circulation, install flow/check valves or other
automatic devices to prevent gravity circulation of the
boiler water during cooling cycles.
Cold
Water
Fill
T P T P
System
Supply
System
Return
System Piping can be
attached on either side of the
Instinct Floor Standing Boiler
Manual
Air Vents
System Piping can be attached
on either side of the Instinct Floor
Standing Boiler