TransCore encompass 4, Руководство пользователя

Страница: 157 / 208

Table 45 ID Separation Commands
Command Option
#4100 Separation of 1 ID
#4101 Separation of 2 ID
#4102 Separation of 3 ID
#4103 Separation of 4 ID
Note:
The dual-protocol Encompass 4 Reader internal timing varies depending on the operative tag
read mode and the type of tag in the read field.
See section “610 Select Basic Communication Protocol (Factory Default)” on page 7–114 and section
“410N Select Unique ID Code Criteria (Anti-passback Feature)” on page 7–94 .
To set ID separation parameters
1. Ensure that the host computer is in command mode.
2. Enter command
#4100 to select a separation of one ID; enter command #4101 to select a
separation of two IDs. Press ENTER .
Reports
The Encompass 4 Reader can be configured to transmit presence without tag reports and input status
change reports. A presence without tag report is transmitted in data mode only, and only if the system has
a presence detector . This report is sent if a presence is detected without the detection of a valid tag ID.
See sections “529 Display Presence Input Status” on page 7–108 and “690N Select Presence Without
Tag Report Option” on page 7–126.
If configured with command #82N Select Input Status Change Report Option to transmit
input status change reports, the reader will transmit a message to the host computer any time the inputs
change state. Input status change reports are transmitted in data mode only. Input status change reporting
is disabled by default. See sections “560 Request Sensor Status Change” on page 7–112 and “82N Select
Input Status Change Report Option” on page 7–131 . Also refer to “Chapter 6 Communications Protocols”
on page 6–71 for information on message formats.
To set presence reporting
1. Ensure that the host computer is in command mode.
2. Enter command
#529 to display presence input status and press ENTER . P0 indicates presence
without tag reports disabled (factory default), and P1 indicates presence without tag reports enabled.
3. Enter command #6901 to enable presence without tag reports, or enter command #6900 to disable
presence without tag reports (factory default). Press ENTER .
To set input status change reporting
1. Ensure that the host computer is in command mode.
2. Enter command
#560 to display input status change report options and press ENTER .
Encompass 4 Reader System Guide
TransCore Proprietary.
8–140