TransCore encompass 4, Руководство пользователя

Страница: 127 / 208

Encompass 4 Reader System Guide
TransCore Proprietary.
7–110
V0 Valid ID code criteria of one acquisition ( #4200)
V1 Valid ID code criteria of two acquisitions
(#4201)
V2 Valid ID code criteria of three acquisitions
(#4202
)
V3 Valid ID code criteria of four acquisitions (#4203)
For example, if factory default settings are assigned, the reader message is
RF0S U0 V0
which means separation of one ID for uniqueness filtering and a valid ID code criteria of one acquisition.
532 Display Wiegand Mode Status
See “450 Disable Wiegand Mode (Factory Default)” on page 7–96 and “451 Enable Wiegand Mode” on
page 7–96 .
Command
#532
displays the Wiegand mode status as either enabled or disabled. Reader message:
TOF <0 to 1>
where
0
Wiegand mode disabled ( #450 )
1 Wiegand mode enabled
(#451)
533 Display Wiegand Retransmit Interval
See command “46NN Set Wiegand Retransmit Interval” on page 7–98, “46NN Set Wiegand Retransmit
Interval” on page 7–98.
Command #533 displays the Wiegand retransmit interval. This interval specifies the delay in seconds
before the reader retransmits Wiegand data for a tag still in the read zone. The factory default is 1 second.
Reader message:
WTI <01 to FF>
where
01 to FF = seconds (1–255) in hexadecimal.
Note:
The actual value of the Wiegand retransmit interval may vary depending on the operative tag
read mode and the type of tag in the read field.
For example,
10
= 16 seconds and
FF
= 255 seconds. The retransmit interval in ATA tag read mode is
about twice these values.
534 Display Tag Translation Mode Status
Command #534 displays tag translation mode status, enabled or disabled. If tag translation mode is
enabled, incoming full-frame tags in AAR or ATA format are translated according to ISO standards. Refer
to “452 Disable Tag Translation Mode (Factory Default)” on page 7–97 and “453 Enable Tag Translation
Mode” on page 7–97 for more information.