Transcell Technology TI-500 Plus, Руководство по установке и эксплуатации

Страница: 11 / 82

9
A30
Backlight
Setup
Allows you to permanently disable the backlight feature for outdoor
use.
"OFF" = Always OFF “ON" = Always ON “AUTO” = automatic
Auto

(NA/€)
ON OFF
A34
Decimal Point
Selects printed (not displayed) decimal point character.
"0" = Period (‘.’)
"1" = Comma (‘,’)
0 (NA)
1 (€)
A37
Battery Setup
Sets the type of battery used in the battery compartment; vital to
accurate low battery warning:
"0" = 1.5 V (alkaline)
"1" = 1.2 V (Ni-Cad or Ni-MH rechargeable)
0
1 (NA/€)
USER MENU PROCEDURES
This section provides instructions for all of the User Menu procedures.
ID Number Entry (A8)
1. While in the User Menu mode, scroll to " A 8 ", then scroll down once using the ZERO key to enter
the ID Number menu.
2. The display will momentarily show " ID NO ", followed by a value with one flashing digit. This value
will be the current ID number value.
3. Use the four directional keys (shown below) to adjust the displayed value to the actual ID Number
value. Increase the flashing digit by pressing the UNITS key. Decrease the flashing digit by
pressing the ZERO key. Pressing the PRINT key or the TARE key will change the position of the
flashing digit.
USER MODE KEY FUNCTIONS
ZERO
GROSS
NET
TARE PRINT
SET
UNITS
4. After setting the exact value, press the NET/GROSS key to save the ID Number value. The
display will show "
SET " momentarily, and then revert back up to A8.
LF (Line Feeds) Number Entry (A9)
1. While in the User Menu mode, scroll to " A 9 ", and then scroll down once using the ZERO key to
enter the Line Feeds menu.
2. The display will momentarily show " LF ", followed by the current line feeds value.
3. Use the four directional keys shown in Figure 11 to adjust the displayed value to the actual line
feeds value. Increase the flashing digit by pressing the UNITS key. Decrease the flashing digit by
pressing the ZERO key. Pressing the PRINT key or the TARE key will change the position of the
flashing digit.
4. After setting the exact value, press the NET/GROSS key to save the line feeds value. The
display will show " SET " momentarily, and then revert back up to A9.