Trans-Cal SSD120-N-RS5, Инструкция для владельца и по установке, Страница: 24 / 57

Page 24 of 57
( S10 represents Set 10,000 feet ) The digitizer will now output 10,000 feet based on the current
input pressure. The PC will display the altitude at which the digitizer will make this change. In the
example referenced above, the PC would display
>10000.
18. Proceed to the next 1000-foot mark and repeat the procedure, as in step 8 above, until the
entire operating range of the digitizer is completed.
Note:
a) If no correction is required at an altitude simply do not enter a correction.
b) Do not adjust the high or low potentiometers during this procedure.
c) You may quit the adjustment program at any time by typing “
Q
” twice; the digitizer
output will then be displayed on the PC screen in normal operation mode.
19. After completing the above procedure you may examine the corrections entered into the
EEPROM. Type “
D<enter>
” to display the EEPROM data and read the current error curve
on the PC screen. The following table should appear:
00= 000
01= 000 02= 000 03= 000 04= 000 05= 000
06= 000 07= 000 08= 000 09= 000 10= 000 11= 000
12= 000 13= 000 14= 000 15= 000 16= 000 17= 000
18= 000 19= 000 20= 000 21= 000 22= 000 23= 000
24= 000 25= 000 26= 000 27= 000 28= 000 29= 000
30= 000 31= 000 32= 000 33= 000 34= 000 35= 000
36= 000 37= 000 38= 000 39= 000 40= 000 41= 000
42= 000 43= 000 44= 000 45= 000
90= 000 91= 000 92= 000 93= 000 94= 000 95= 000
96= 000 97= 000 98= 000 99= 000
>current altitude
The first two digits represent altitude x1000 feet and the last three digits after the equal sign represent the
amount of error introduced at the altitude in feet.
Note: Fields 90 = 000 through 99 = 000 contain TCI calibration data and are not user accessible.