Trans-Cal SSD120-N-RS5, Инструкция для владельца и по установке, Страница: 20 / 57

4.6 Hyper Terminal Set-Up on the IBM Compatible PC
Boot up the computer and start the serial data capture software such as the
Hyper Terminal
program. Hyper Terminal may be located in the Programs section or in the Accessories section
under
Communications
, and Hyper Terminal will be used for the balance of the examples used in
this manual.
Under the New Connection window:
Choose an icon then select an identifying title such as “Test.”
Select
OK
after you have made your choices.
Under
the Connect to window:
-Choose
Connect Using Com 1
or whatever
Com
port you have chosen to use.
After your selection click on
OK.
Under
the Com ? Properties window:
Select the
Port Settings
tab and set the following:
Bits per second:
9600
Data bits:
8
Parity: None
Stop Bits:
1
Flow Control:
None
Select OK
In the
Hyper Terminal
window select
File
then click on
Properties
.
Under
the Com ? Properties window click on the Settings tab.
Set the following:
Function, arrow, ctrl keys to act as
Terminal Keys.
Emulation to Auto Detect
Under
ASCII Setup
Set the following:
Echo off.
Wrap lines that exceed terminal width.
Select
OK.
The software is now configured for operation.
Note: Past versions (Ver. 5 thru 6) of HyperTerminal have a known issue when communicating with serial
protocols of 7 data bits, 1 stop bit, odd parity. This Windows® program will not correctly auto detect the protocol,
but will display the data when manually configured.
Page 20 of 57