Trane SCWM, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 92

PKG-SVX027C-EN 31
N NO OT TIIC CE E
P Prro op pe err W Wa atte err T Trre ea attm me en ntt R Re eq qu uiirre ed d!!
T Th he e u usse e o off u un nttrre ea atte ed d o orr iim mp prro op pe errlly y ttrre ea atte ed d w wa atte err
cco ou ulld d rre essu ulltt iin n sscca alliin ng g,, e erro ossiio on n,, cco orrrro ossiio on n,, a allg ga ae e o orr
sslliim me e..
U Usse e tth he e sse errv viicce ess o off a a q qu ua alliiffiie ed d w wa atte err ttrre ea attm me en ntt
ssp pe ecciia alliisstt tto o d de ette errm miin ne e w wh ha att w wa atte err ttrre ea attm me en ntt,, iiff
a an ny y,, iiss rre eq qu uiirre ed d.. T Trra an ne e a assssu um me ess n no o rre essp po on nssiib biilliitty y
ffo orr e eq qu uiip pm me en ntt ffa aiillu urre ess w wh hiicch h rre essu ulltt ffrro om m u un nttrre ea atte ed d
o orr iim mp prro op pe errlly y ttrre ea atte ed d w wa atte err,, o orr ssa alliin ne e o orr b brra acckkiissh h
w wa atte err..
Condenser water piping connections are located on the
right or left hand side of the unit (depending upon
configuration required). All field-installed piping must
conform to applicable local, state, and federal codes.
To complete condenser water connections follow the
procedure below.
1. Evaporator module should be in its final location
and isopads installed if necessary, see Figure 10, p.
23
2. Set condensing unit and spacer cassettes in place
just in front of evaporator module and line up
refrigerant connections.
3. Install 3" water pipe between condensing unit
cassettes ensuring that condenser water bracket is
in place on each cassette to support the water
pipes. Depending upon the tonnage and right hand/
left hand configuration, there will be one or more
sets of 3" pipe that will need to be installed between
cassettes. Refer to the following figures for typical
installation.
Figure 13. Condenser water bracket
Condenser
Water Bracket
Figure 14. Condenser cassettes-1
Figure 15. Condenser cassettes-2
4. Ensure that 3" tee strainer (ship with) is installed on
inlet water connection.
5. Attach the water supply line to the inlet of the tee
strainer, and the return line to the outlet
connection. If the unit has a waterside economizer
and/or control valves, these components will need
IIn nsstta alllla attiio on n -- M Me ecch ha an niicca all