Trackmaster TMX428, Руководство по обслуживанию

Страница: 41 / 159

TRACKMASTER Ch. 6 Operating Instructions
317-160-406 Rev 4 TMX428 TMX428CP & TMX58 Service Manual 39
May 2021
Operating Instructions
Before operating the TMX428 and TMX428CP, familiarize yourself with the following safety
control features of the treadmills.
Electrical Safety Tests
The electrical safety of this installation is the responsibility of the customer, not Full Vision, Inc
(TRACKMASTER
®
). In hospitals, contact your in-house biomedical technician, electrician, or
technically qualified personnel. Outside of hospital, contact your hospital affiliation of these
services.
Before using the treadmill, have qualified personnel perform the test listed below:

AC line voltage test to verify the power outlet is properly wired.

Ground continuity test to verify all exposed metal is properly grounded.

Leakage test to verify the equipment passes all applicable leakage tests.
Your in-house biomedical technician, electrician, or technically qualified personnel can find
instruction for performing these tests in the TMX428/TMX428CP Treadmill Service Manual.
Operating Controls
The TMX428 treadmill has three operating controls: the power switch, emergency stop switch,
and pull tether. The power switch is located on the rear panel, the emergency stop is located on
the right-hand rail, and the pull tether is located on the left handrail (Optional on opposite side).
Controlling the Treadmill

Turn the power switch ON ( I ).

Use the controlling equipment to start the treadmill, adjust the treadmill speed and grade,
proceed through exercise phases, terminate the exercise session, and turn off the
treadmill. Refer to the appropriate controlling equipment Operator Manual for
instructions.
Power Switch
The power switch controls the AC power to the treadmill. The ON position ( I ) applies power. The
Off position (O) removes power.
6