Trackmaster TMX428, Руководство по обслуживанию

Страница: 124 / 159

TRACKMASTER Ch. 12 Established Component Replacement Times
122 TMX428 TMX428CP & TMX58 Service Manual 317-160-406 Rev 4
May 2021
Elevation Calibration Procedure (Controller Interface)
Tools Required
Tape Measure
¼” Nut Driver or Flat Headed Screw Driver
T15 Torx Screw Driver
1. Plug treadmill to power supply.
2. Turn ON Treadmill.
3. To set the 0% Elevation and Upper Elevation Limits.
4. Start treadmill, increase elevation to 5% and cycle treadmill power (by resetting the
power, the treadmill will automatically find the lower limit position).
5. Using a tape measure, verify the 0% elevation (Refer to Elevation Chart TMX428,
TMX428CP, and TMX58).
5A. If the zero position requires adjustment, remove actuator top cover.
NOTE: The treadmill can have either Von Weise or MSI Actuator. The difference is how
the Zero Position is adjusted.
Von Weise Actuator MSI Actuator
5B.
If the Zero Position is low, adjust the upper cam clockwise into the limit
switch. If position is high adjust the upper cam counterclockwise away
from limit switch.
Von Weise Actuator MSI Actuator
NOTE: When adjusting the upper cam on the Von Weise Actuator, an audible click will
be heard. Make adjustments in small increments, preferably a single click at a time.
When adjusting the upper cam on the MSI Actuator loosen screw to relieve tension then position upper
cam. This is a friction fit, be careful to move in small increments, tighten screw when complete.
5C. Repeat step 8 to reestablish 0% elevation.
6. To gain access to the parameter screen hold down
on
QUICK SPEED
for approximately 4 seconds.
7. Using the ENTER or PROGRAM SELECT
4