Trackmaster TMX428, Руководство по обслуживанию

Страница: 127 / 159

TRACKMASTER Ch. 12 Removal and Replacement of Components
317-160-406 Rev 4 TMX428 TMX428CP & TMX58 Service Manual 125
May 2021
TMX428CP & TMX58 PARAMETER SCREEN
To gain access to the parameter screen hold down on
QUICK SPEED
for approximately 4
seconds.
Parameter screen description:

P02 Stop History

P05 Maximum Speed Setting

P09 Accurate Speed B (External Sensor)

P10 Firmware version (Lower Board)

P14 Accurate Speed A (Motor Controller)

P15-P20 Elevation Calibration Points

P22 Run Time

P30 Calibration Fail Code (0=Calibrated)

C00 Setting = 1 Quick Speed Enabled
Setting = 3 Quick Speed Disable

C01 Minimum Start Speed 0.0 to 1.0 MPH

C02 Maximum Elevation

SPD Manual Control Speed Any +or- Key

ELE Manual Control Elevation Any +or- Key
NOTE: Do not alter any parameter values with Consulting the factory. Altering the
parameters may cause the treadmill to malfunction.
TMX428CP & TMX58 STOP HISTORY
To view history highlight the P2 parameter and hold down on the QUICK SPEED 2 for
approximately 5 seconds.
Using the + or
–
key, this allows you to highlight a specific stop code and receive a breif
description for stopping (Example 34 is NORMAL STOP).

Start Rejected (8 or 40)

Stop due to kill switch open (16 or 48)

Motor Controller Fault (64 or 96)

Overspeed Motor Controller (128 or 160)

Overspeed External Speed Sensor (256 or 288)

Speed Delta Error (512 or 544)

Set Speed to Zero Command (1024 or 1056)

Auto Stop Command (2048 or 2080)

Measured Zero Speed Error (8224)
TMX428 VERSION 0.4C
ENTER: NEXT PROG: PREV +- EDIT START: EXIT
P00 1 P01 400000 P02 33 P03 160
P04 100 P05 150 P06 0 P07 0
P08 0 P09 0 P10 135 P11 1000
P12 25 P13 14925 P14 0 P15 19
P16 96 P17 198 P18 305 P19 400
P20 495 P21 990 P22 11 P23 35
P24 0 P25 160 P26 342 P27 1000
P28 1000 P29 7615 P30 0 P31 0
P32 0 P33 4000 P34 0 P35 5
P36 7 P37 4753 C00 1
C01 0.1 C02 25.0 SPD 0.0 ELE 0.0
STOP HISTORY (00=MOST RECENT)
+- SELECT COOL DOWN:EXIT
#00
34 #01 544 #02 34 #03 34
#04 34 #05 34 #06 34 #07 34
#08 34 #09 34 #10 34 #11 34
#12 34 #13 34 #14 34 #15 34
#16 34 #17 34 #18 34 #19 34
NORMAL STOP
4