Trackmaster TMX428, Руководство по обслуживанию

Страница: 128 / 159

TRACKMASTER Ch. 12 Established Component Replacement Times
126 TMX428 TMX428CP & TMX58 Service Manual 317-160-406 Rev 4
May 2021
Firmware Download FGLF0495-1 (3
rd
Edition Smart Power Supply)
1. Copy the FVProg.ROM to a Micro SD card (consult factory for the
correct firmware version).
2. Locate the main power switch and set the switch in the off position.
3. Remove the motor pan hood screw to gain access to the Smart
Power supply circuit board.
4. Insert the SD card into the SD card reader slot as shown at right.
5. Switch the main power switch to the ON position. Be sure to keep hands away from electrical
components which may cause a shock hazard.
6. There is a LED at D13 that will flash at a slow rate of 0.5 seconds per flash while the system is
searching for the SD card and reprogramming the processor.
7. Once the program is loaded, the LED should light solid. The down relay will also turn on to initialize
the system. The D13 will flash once per second; this requires a speed calibration before returning to
service.
Firmware Download FGLF0495-3 (4
th
Edition Smart Power Supply)
1. Copy the FVProg18.ROM to a Mini Micro SD card (consult factory
for the correct firmware version).
2. Locate the main power switch and set the switch in the off position.
3. Remove the motor pan hood screw to gain access to the Smart
Power supply circuit board.
4. Insert the SD card into the SD card reader slot as shown at right.
5. Switch the main power switch to the ON position. Be sure to keep hands away from electrical
components which may cause a shock hazard.
6. There is a LED at D13 that will flash at a slow rate of 0.5 seconds per flash while the system is
searching for the SD card and reprogramming the processor.
7. Once the program is loaded, the LED should light solid. The down relay will also turn on to initialize
the system. The D13 will flash once per second; this requires a speed calibration before returning to
service.
Firmware Download FGLF0496 (3
rd
Edition LCD Control)
1. Copy the THORCONS.ROM to a Micro SD card (consult factory for
the correct firmware version).
2. Locate the main power switch and set the switch in the off position.
3. Remove the upper plastic console screws (10X) to gain access to
the LCD Screen circuit board.
4. Insert the Micro SD card into the SD card reader slot as shown at right.
5. Switch the main power switch to the ON position. Be sure to keep hands away from electrical
components which may cause a shock hazard.
6. There is a LED at LED1 that will flash at a slow rate of 0.5 seconds per flash while the system is
searching for the SD card and reprogramming the processor. During the download process the LCD
screen will remain black until the new firmware has been fully loaded.
7. Once the program is loaded, the LED should rapidly flash. The blue screen will display the Welcome
Screen.