118
Chapter 5
Configure the Router in WISP Mode (Hotspot Mode)
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
Note:
• To access the router, enter your router’s WAN IP address in your browser’s address bar, followed by a colon and
the custom port number. For example, if your router’s WAN address is 202.96.12.8, and the port number used is
8080, please enter http://202.96.12.8:8080 in your browser. Later, you may be asked for the router’s password. After
successfully entering the username and password, you will be able to access the router’s web management page.
• Be sure to change the router’s default password for security purposes.
5. 16. 10. System Log
1. Visit
http://tplinkwifi.net
, and log in with the username and password you set for the
router.
2. Go to
System Tools
>
System Log
, and you can view the logs of the router.
•
Loge Type
-By selecting the log type, only logs of this type will be shown.
•
Log Level
- By selecting the log level, only logs of this level will be shown.
•
Refresh
- Refresh the page to show the latest log list.
•
Clear Log
- All the logs will be deleted from the router permanently, not just from the
page.
5. 16. 11. Statistics
1. Visit
http://tplinkwifi.net
, and log in with the username and password you set for the
router.
2. Go to
System Tools
>
Traffic Statistics
.
3. Select
Enable
and click
Save
. You can view the network traffic of each PC on the LAN,
including total traffic and the value of the last Packets Statistic interval in seconds.
Downloaded from