E2. Setting and Operation of Towel Loom Beam-
relatedFunction Panel
Touch the [ Map ]
–
[ Letoff ] icon.
[1] Setting for bottom beam control
In the two-stage tension specifications, set the tension for
border weaving higher than that of pile weaving.
When two-stage tension is not applied, set them with the
same numerical value.
Or, when 0 kg is set as the tension for border weaving, the
tension applied for pile weaving is applied for border
weaving as well.)
The items regarding pile
→
border adjustment is effective
at the time of two-stage tension change is applied.
The kilogram value shown at left indicates a numerical
value to adjust the high tension at the time of the tension
change.
This numerical value is the one to correct the difference
that may occur by machine when fixing a cylinder while
tension is high, though the inclination that is applied to
the load cell changes accordingly. When the tension is
lower than the actual one, increase the numerical value
within the range of approximately 20-35.
The setting value of the pick for pile
→
border
adjustment or border
→
pile adjustment is to make the
speed of the tension change faster at the time of
switching.
Setting the number of pick continuously controls the
motion to strain or loosen the let-off during the
designated number of picks.
Set it within the range of approximately 0-5.
E2. Setting and Operation of Towel Loom Beam-relatedFunction Panel
54
