M9. Electronic Terry Motion
This section describes the mechanical points of the electronic terry motion. The related electrical details are given in
Section E6.
[1] Adjusting the Stoppers
Adjust the stoppers (there is once each at the RH and LH sides) according to the steps below.
(1) Set the crank angle at 0
°
on the first pick or ground
weaving.
(2) Press and lock the emergency stop button.
(3) Loosen nut 2 of stopper 1.
(4) Turn stopper 1 by hand until the clearance of the
expansion bar lever 3 becomes 0.1 to 0.2 mm.
There is stopper 1 each on the left and right sides (2
pieces in total). Check that the clearance on the left
and right sides is 0.1 to 0.2 mm.
NOTE
: Make an adjustment again during operation
so that the clearance between stopper 1 and
lever 3 becomes 0.1 to 0.2 mm.
(5) Tighten nut 2 to secure stopper 1.
NOTE
: Check stopper 1 and lever 3 again during
operation for excessively strong contact
with each other, and adjust for light contact.
M9. Electronic Terry Motion
42
