2) [Mounting a flange opposite to the yarn beam gear side]
(5) Make a mark on "Drawing-in width
–
(2
×
Selvage textural width)
+
0 to 10 mm"
=
L mm
from the right side on the mark made in step (1).
NOTE:
The minimum effective drawing-in
width relative to each drawing-in width
is -70 cm.
(6) Screw-in yarn beam flange 3 from the direction
of "B" until inside yarn beam flange 3 becomes
aligned with the mark made in step (5).
• For making the screwing-in job easier, apply
grease or oil to the threaded section.
(7) Screw-in flange ring 5 also in the direction of "
B" until the gap from the end of yarn beam
flange 3 to that of flange ring 5 comes to 3 to 5
cm. Align bolt holes provided in flange ring 5
with those in yarn beam flange 3, then tighten
bolts.
※
In case that left trimmed selvage is taken from the
trimmed selvage stand in accordance with the
specification for left trimmed selvage, the beam
should be set as shown in the figure below.
Also, the maximum textural width is 40 mm
shorter than the drawing-in width (for example, in
case of R/260, the maximum textural width is 2,
560 mm).
＜
Gland beam
＞
The left flange's inside should become aligned at
the point where X
=
125 mm from the end a of yarn
beam.
＜
Pile beam
＞
The left flange's inside on the left side should
become aligned at the point where X
=
150 mm
from the end a of yarn beam.
In the above-mentioned case, both gland beam and
pile beam should be fixed with using flange ring 5.
M1. Preparation for Setting
5
