4. APPENDIX
134
4.3.5
Works after Determining TMS Scanner Introduction
The section explains our works and the works to be done by the customer after determining TMS
scanner introduction.
[ 1 ] Matters to be Checked upon Determining Introduction
(Discussion between The Customer and Us)
•
Confirmation of the model and number of looms to be connected to the TMS
•
Loom layout check
•
Signal cable conduit installation work method
•
Number of channels
•
Cable length
* We will prepare the loom connection diagram and check it with the customer.
[ 2 ] Signal Conduit Installation Work (Customer’s Work)
•
Conduct the signal conduit installation work as described in 4.3.4 “Studying Loom Connection to
TMS Scanner PC”.
[ 3 ] Sending The Cable and Scanner PC (Our Work)
•
We will send the required cables and scanner PCs as checked in [ 1 ] above.
* The customer should check the contents of the supplied goods.
[ 4 ] Preparation of The TMS-PC (Customer’s Work)
•
Aside from the scanner PC sent in [ 3 ], a computer installed with TMS is necessary.
(This is unnecessary if the TMS for JAT710 has already been operating.)
•
To prepare it anew, the following recommended conditions must be satisfied:
Machine compatible with preinstalled model PCAT allowing full running of “Microsoft Windows
2000” or “Microsoft Windows XP”
CPU:
Frequency at 800 MHz or above
Memory: 256 MB or more
HDD:
Hard disk with an empty space of 2 GB or more in drive C
LAN:
Installation of Ethernet port as the network interface.
(Should match 100BASE-TX or 10BASE-T.)
OS:
Microsoft Windows 2000 or Microsoft Windows XP
Others: Display, keyboard, mouse, etc.
The TMS requires application software:
Microsoft Excel 2000 and Microsoft Internet Explorer.
