Toyota 7BPUE15, Руководство по обслуживанию

Страница: 264 / 411

Toyota Orderpicker Model 15 Service Manual Section 8. Wire Guidance
Install Kit Components
Install Kit Components
Before installing kit components, turn the key
switch OFF, disconnect the battery and remove
the appropriate covers.
N
OTE
: Once you install all the components,
complete the Set-Up Procedure
beginning on 8-9.
Guidance Manager (Steer
Controller Card and Filter Card)
The guidance manager is a n assembly
comprised mainly of a steer controller card and
a filter card. The wire guidance firmware is
housed in the WSI module.
1. Wear a static strap and insert the WSI
module 00590-458 18-7 1) into the
socket on the steer controller card. See
Figure 8- 1.
Figure
8- 1 .
Steer Controller C a r d
2. Install the steer controller card assembly
00590-459 10-7 1) on the electrical
panel with four hex spacers
00590-02988-7 1). See Figure 8-2.
3. Install the filter card assembly
00590-45747-71) on the steer controller
Figure Guidance Manager, Installed
4. Install the power and ground cable
00590-4588 1-71) to connector PS2 on the
steer controller card. Route the wires
through the wiring channel along the
manager to SPL3 and TP4 a s
shown on the schematic. (See Figure A-6
on page A- 13.) Use cable ties a s necessary.
5. Install the CAN b u s wiring harness
00590-45881-71) to PS4 on the steer
controller card. Route the harness along
the existing wiring to the
manager connector
Use cable ties a s
necessary.
card. Secure with four screws
Figure Load Sensor Assembly, Installed
00590-45925-7 1) in the hex spacers. See
Figure 8-2.
00700-CL222-05, 1 5 March 2005