Toyota 7BPUE15, Руководство по обслуживанию

Страница: 222 / 411

Toyota Orderpicker Model 15 Service Manual
Section 7 . Component Procedures
Hydraulic Components
Hydraulic Reservoir
Hydraulic Reservoir
Remove
1. Turn the key switch to OFF and
disconnect battery.
2.
Remove top and tractor covers.
3.
Drain the hydraulic fluid. See "Hydraulic
Fluid" on page 7-60.
4.
Disconnect the warning light and hour
meter wires.
Reservoir
Tube
Figure
7-87.
Hydraulic Reservoir, Installed
5. Remove the filler breather cap and strainer
from the top of reservoir. See Figure 7-87.
6. Remove the six screws that hold the
return line bracket to the reservoir.
7. Remove the tube weldment. See
Figure 7-87.
8. Remove the bracket located behind the
drain and suction hoses.
9. Slide the reservoir out of the tractor.
Install
1. Fit the grommet and protrusion in the
bottom of the tank and install the bracket
that holds the suction and drain hoses.
2.
Slide the new tank in place in tractor.
3.
Install the bracket behind the drain and
suction hoses.
4.
Lubricate O-ring with clean hydraulic fluid
and install.
5. Install tube weldment.
6. Install strainer and filler breather cap. See
Figure 7-87.
N
OTE
: To help prevent the hoses from slipping
off the protrusions on the reservoir:
Clean and dry the hoses and
protrusions
Make a rough surface on the
protrusions
7. Attach hoses. Tighten the clamp as close
as possible to the top of the hose.
1 5 March 2005