Toyota 7BPUE15, Руководство по обслуживанию

Страница: 251 / 411

Section 7. Component Procedures Toyota Orderpicker Model 15 Service Manual
Mast Disassembly and Shimming
4. Use spare as a gauge to determine
the amount required to move the roller
bearings outward to make contact with the
main frame.
5. Remove the outer mast from the main
frame.
6. Remove the roller bearings from both roller
bearing bosses a t the bottom of the outer
mast.
7. Install half of the total shim thickness
required to each roller bearing boss a t the
bottom of the outer mast. (Applying one
half of the total shim thickness to each
side of the mast maintains the center line
of the mast assembly.)
8. Reinstall the roller bearings. Torque the
bolts per Table 7-2.
9.
Use a suitable lifting device and reinstall
the outer mast into the main frame. Check
for tightness while moving the outer mast
to the bottom of the main frame.
shims as necessary to
maintain a snug, but free-running, fit.
N
OTE
: If the outer mast hangs up, a pry bar
may be used to move the mast.
10. Assemble the two top mainframe roller
bearings and bosses without shims.
1 1. Install the roller bearing assemblies,
attach with a retaining bolt, and snug up
to the main frame.
N
OTE
: Failure to snug the assemblies to the
main frame will result in the wrong
amount of shims, since the studs are
canted.
12. With the outer mast fully nested, use a pry
bar and carefully move the outer mast to
the opposite side. Using spare shims
between the bearing and outer mast,
determine the amount of shims required
to remove side play.
13. Remove the roller bearing assemblies.
14. Install half of the total shim thickness to
each roller bearing assembly.
15. Install the roller bearing assemblies and
attach with the mounting bolts and
tighten.
Mast Section
16. With the outer mast fully nested, use a pry
bar to check for bearing tightness. If more
shims can be inserted between the bearing
and the outer mast, remove the roller
bearing assembly and install the
Reinstall the bearing assembly.
17. Check for proper shimming by pulling the
outer mast out and then pushing it in all
the way. The outer mast should not hang
up while moving it in and out. Torque the
bearing stud retaining bolts (refer to
Table 7-2 on page 7-86)
.
18. Install the stops in the mainframe.
Shimming Outer Mast to Inner
Mast
1. Install the mast roller bearings a t the
bottom of the inner mast.
Mast assembly may swing free when
lifting. Use extreme caution.
2. Use a suitable lifting device and insert the
inner mast into the outer mast all the way
to the bottom.
3. Use a pry bar and carefully move the inner
mast and bearings to one side.
4. Use spare a s a gauge to determine
the amount required to move the bearings
outward to make contact with the outer
mast.
Failure to properly balance load may
result in personal injury. Use extreme
caution.
5. Remove the inner mast from the outer
mast.
6. Remove the bearings from both roller
bosses a t the bottom of the inner mast.
7. Install half the total shim thickness
required to each roller boss a t the bottom
of the inner mast.
00700-CL222-05, 1 5 March 2 0 0 5