Toyota 7BPUE15, Руководство по обслуживанию

Страница: 228 / 411

Toyota Orderpicker Model 15 Service Manual Section 7 . Component Procedures
Hydraulic Components Side Cylinder
Side Cylinder
4.
Remove the bolt in the top of the lift
cylinder that connects it to the bracket on
mast.
5. Elevate the platform until it clears the ram
assembly enough to allow removal
Use extreme care whenever the truck
is
6.
Block the carriage and mast.
jacked up. Never block the truck
7. Remove the snap ring from the bottom of
between the mast and the floor. Keep
the cylinder. See Figure 7-97.
hands and feet clear from vehicle while
jacking the truck. After the truck
is
jacked, place solid blocks beneath it to
support it. DO NOT rely on the jack
alone to support the truck. See "Jacking
Safety" on page
2- 1 1.
N
OTE
:
Using a mirror will enable you to see the
snap ring a t the bottom of each cylinder
housing in the following procedures.
Remove
1. Elevate the platform far enough to access
the tubing that connects to the bottom of
the lift cylinder but not far enough to
Figure 7-97. Bottom View of Housing (Using
extend the side cylinder. Block the carriage
in place.
8. Remove the bolt that attaches the cylinder
2. Remove the tubing from the bottom block
housing to the main frame of the truck.
on the cylinder that is to be removed and
See Figure 7-98.
cap both the tubing and the fitting to the
lift cylinder.
Figure 7-96. Hydraulic Connection, Side Cylinder, Bottom
3.
Unblock and lower the platform to the
Figure 7-98. Side Cylinder
floor.
9. Remove the lift cylinder from the truck.
00700-CL222-05, 1 5 March 2005