Installers Information
TAB(S) 3 IN TOTAL ALONG EDGE
11. Reach in to disconnect the electrical connector (Figure 36).
12. Disconnect the gas connector at the base of the flexible line using a 3/4 inch wrench (Figure 37).
13. The gas valve assembly can now be removed from the HeliFire 360 (Figure 38).
Reinstalling the Burner Control / Valve assembly on a single window unit.
Reinstalling the gas valve assembly is the reverse of removing it.
1. Place the gas valve assembly into the firebox cavity and slide it in far enough so that the gas and electrical connec-
tors can be re-attached (Figure 37 and Figure 36).
2. Slide the gas valve assembly back into place and secure using two 5/16 Allen screws (Figure 35 and Figure 34).
3. Position the rear decorative panel into place by sliding the edge with the 3 tabs underneath the panel with the air
vents until it lays flat in the firebox cavity (Figure 39 and Figure 40) and the holes line for the end covers line up.
Ensure that the curved edges of the end covers are placed against the rear plate (Figure 41).
4. Reinstall the glass door and the outer decorative trim.
5. Turn on the electrical and gas supply.
REAR PANEL
ELECTRICAL CONNECTOR
Figure 36: Disconnect electrical
connector.
Figure 37: Removing gas connection.
Figure 38: Gas valve assembly
removed.
Figure 39: Tabs to slide underneath
the air vents.
Figure 40: Rear decorative panel in
place with screw holes lined up.
Figure 41: Curvature of end cover plate.j
20
TCHF.22bodya_ 090617-36
TCHF.22STbodya
5055.64-a
