Installers Information
Removing the Burner Control / Valve assembly on a single window unit.
1. Turn off the electrical supply at the main breaker.
2. Turn off the gas supply to the HeliFire 360.
3. Remove the decorative window trim to expose the 18 bolts which fasten the glass door to the HeliFire 360.
4. Remove the glass door.
5. Remove burner / igniter assembly as described on page 16.
6. Note: The rear decorative panel has a bow built into it which will restrict the gas valve assembly from being removed,
therefore the decorative panel must be completely removed.
7. Remove burner end and exhaust end cover plates screw using a 5/16 Allen key (Figure 30 and Figure 31).
8. Once both end covers are removed, the rear decorative plate can be removed. One edge of the rear plate has 3 tabs
which fit underneath the air vents. The opposite edge will need to be lifted first in order to slide the tabs from under-
neath the air vents (Figure 33).
9. Remove the two 5/16 Allen screws which secures the gas valve assembly to the body of the HeliFire 360 (Figure 36).
10. The entire gas valve assembly can be slid in towards the firebox cavity (Figure 35).
EDGE OF PLATE WITHOUT HOLD
DOWN TABS
SECURING SCREWS
EXHAUST END COVER PLATE
Figure 30: Rear decorative panel
with bow visible.
Figure 31: Exhaust end cover plate.
Figure 32: Removing exhaust end
cover plate.
Figure 33: Removing rear decorative
plate.
Figure 34: Removing gas valve assy
securing screws.
Figure 35: Sliding gas valve assy
toward firebox cavity.
19
5055.64-A
TCHF.22bodyA_ 090617-36
TCHF.22STbodyA
