14
Electric Power Only
Assemble the Motor Box
If a glow engine will be installed, proceed to
Engine
Installation
on page 16.
❏
1. Glue the front and back plates of the motor box together.
❏
2. Press the 6-32
blind nuts into one side
of the front plate. Apply
a drop of thin CA along
the edge of each blind
nut to secure it.
❏
3. Glue the top, bottom and sides to the front and back
plates.
❏
4. Glue the four ¼" x ¾" (6mm x 20mm) triangle sticks
inside the motor box between the joints between the sides,
top and bottom.
❏
5. Remove the cooling air intake from the bottom of the
fi rewall. The easiest method is to drill 3/32" (2.5mm) holes
at the six tabs.
❏
6. Use a 3/16" drill bit to drill the appropriate mounting
holes for the motor box. Refer to the sketch on page 16 and
make sure your drill the correct hole locations.
❏
7. Press the 6-32 blind nuts into the holes in the back of
the fi rewall.
❏
8. Attach the motor box to the fi rewall.
