11
❏
7. Check the fi t of the fi n on the fuselage with the CA hinge
and tail gear wire installed. Make sure the tail gear wire is
aligned with the rudder.
❏
8. Apply epoxy in the tail gear wire hole in the fi n. Glue the
fi n to the fuselage. Once the fi n is installed and the excess
epoxy has been wiped off, remove the T-pin in the CA hinge
and apply 6 drops of thin CA to each side of the hinge.
❏
9. Attach the tail gear bracket to the bottom of the fuselage.
Harden the screw holes with thin CA.
❏
10. Install the tail wheel.
Install the Rudder Servo
Note: The elevators will be installed after the rudder control
horn is installed.
❏
1.
Glow only:
We recommend the receiver battery tray be
glued in the fuselage, aft of the servo tray. Before installing
the battery tray, make a hook and loop strap as shown. Install
the strap on the receiver battery tray.
❏
2.
Glow only:
Glue the tray in the fuselage. Place the
receiver battery on a piece of foam and secure them to the
receiver battery tray with the hook and loop strap.
