- 6 -
tousek
/ E_SWING-X_42001005 / 06. 02. 2012
Mounting of welding parts
Mounting of rear welding part
• after having defined the pivotal point (taking into account the mounting measures) attach the rear welding part
(2)
in
that position to the gate column (wall)
and support it with a gusset plate (3) .
Mounting of front welding part
• now attach the front welding part
(1)
in compliance with measure C to the gate wing.
Attention: please note upper/under side
(
see figure page 4)
.
• Please make sure that the gate is fully closed and that the vertical misalignment V = 65mm between the two
welding parts is kept to ensure a levelled mounting of the operator.
• With lean or wooden gates the welding part should not be mounted directly on the gate. Please use for that
a flat steel bar.
• support the front welding part (1) with a gusset plate (3) .
Mounting measures opening
to the
OUTSIDE
SWING X3/1
(standard stroke)
SWING X4/1
(standard stroke)
SWING X4/1LH + SWING X5/1LH
(long stroke)
Application
standard
standard
standard
A (mm)
145
145
200
B (mm)
145
145
200
C (mm)
550
550
570
D (mm)
110
110
145
max. opening angle
100°
100°
95°
max. wing width
3m
4m
X4/1LH: 4,5m
X5/1LH: 5m
Special case: opening to the OUTSIDE
A
B
C
D
OUTSIDE
max. 60mm
