- 4 -
tousek
/ E_SWING-X_42001005 / 06. 02. 2012
2. Installation
Swing gate operator SWING-X
2a. Definition of mounting points
and attachment of welding parts
Installation
Note
•
The mounting points for the front (1) and for the rear welding part (2) should be chosen in accordance of the
mounting measures
(see following tables)
.
• Please note that the measures A, B and D must always be measured from the pivotal point of the gate.
• Furthermore a vertical has to be placed for a levelled adjustment of operator (V=65mm) between the welding
parts.
Mounting points
V=65mm
min. 400mm
driveway top edge
gate column
left gate wing
1
2
1
2
3
left gate wing
INSIDE
right gate wing
3
4
4
4
2
1
General installation notes
• The operator type SWING X is equipped with internal limit stops that can be used for gates below 200kg
and with a wing
width below 3m for adjustment of limit positions OPEN and CLOSED.
Gates with a weight above 200kg and more than 3m gate width can not be used with the internal limit stops,
please use external limit stops (4) for gate limit positions!
particularly in the closed position it is recommended to use always
a floor limit stop
(4)
or Tousek piston rod.
• With lean or wooden gates the welding part should not be mounted directly on the gate. Please use for that a flat steel bar.
• *) Attention: to avoid contaminations and to ensure a long lasting and reliable operation please make sure to keep a
minimum distance of
400mm
to the driveway top edge.
• The mounting points Montagepunkte for the
front (1)
and for the
rear welding part
(2)
should be chosen in accordance
of the below mentioned mounting measures. The adjustment/alignment of the operator should be levelled out
(please
note vertical misalignement (V) of welding parts !).
