Total Gym ELEVATE ENCOMPASS, Руководство пользователя

Страница: 8 / 32

8
ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE
21. CABLE AND PULLEY USE POSITION: Raise the LAT bars to use the
pulleys and cable. Rotate each LAT bar up and parallel with the tower,
ensuring the pull pin engages in the hole of the tower cross arm on both
sides.
22. CHANGING THE PULLEY PIN POSITION: Squeeze the pulley clamp
and move it to the desired position along the LAT bar. Be sure the pulley
clamp engages one of the pin positions on the back of the LAT bar.
FOLDING FOOT HOLDER INSTALLATION
Your Encompass arrives with the folding foot holder, which needs to be
installed. Remove the folding foot holder from the box and install it on the
upper rails.
23. Place the rails at or above
level 10 so you have room to
install the folding foot holder
from underneath the rails. Aim
one pin into the hole of a rail
while holding the folding foot
holder upper bar even with the
middle of the rails.
24. Continue to hold the folding
foot holder upper bar even
with the middle of the rails.
Pull the pin on the other side.
Align and insert it into the
hole in the opposite rail, and
release the pin. Ensure both
pins are fully engaged in the
rails.
Pin
Upper bar
Pin
Pin
25. FOLDING FOOT HOLDER USE
POSITION: Pull up on the upper bar to
engage the folding foot holder for use.
Depress the lever where indicated to
fold down when not in use.
TELESCOPING SQUAT STAND ASSEMBLY
There are two attachments that make up the telescoping squat stand
assembly—the folding platform attachment and the squat stand attachment.
FOLDING PLATFORM ATTACHMENT
26. Stand at the base of the rails facing the tower. Hold the folding
platform with a hand on each post. Partially angle the posts toward the
glideboard. Align the upper fixed pin on the left with the top hole on the
lower rail. Allow the lower pull-pin to press against the plate on the left
side of the rail as you guide the upper fixed pin into the hole.
Lever
ASSEMBLY