7
ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE
ELEVATE
®
ENCOMPASS
TM
OWNER’S GUIDE
15.
NOTE:
LAT bars are specific to each side of the tower. When installed the
pull pin should face toward the back of the tower as shown.
While holding the inside bushing so it does not slide out, insert the left
LAT bar through the outside bushing until it slides through the other side.
NOTE:
To avoid scratching the tower paint when installing, leave a small
gap (the width of two coins) for more clearance between LAT bar and
outside of rail.
Leave small gap as
wide as two coins here.
pull pin
outside
bushing
inside
bushing
16.
Install two disc washers with the words “Face Other Disc” toward each
other on the LAT bar threads on the inside of the rail. Then add 2 drops
of loctite to the threads of the LAT bar.
IMPORTANT!
Disks must be
installed with “face other disc”
text facing each other.
disc
washers
17.
Thread the LAT disc nut on the LAT bar while holding LAT bar handle still
until it is too tight to turn by hand. Then use the LAT nut hex wrench to
tighten the LAT nut completely until it will not turn any more.
LAT
disc nut
LAT nut
hex wrench
18.
Install the plastic cap.
plastic
cap
19.
Repeat the process on the right LAT bar.
NOTE:
After both LAT bars are
assembled, the LAT bars are ready for use.
ADJUSTING THE LAT BARS
20.
PULL-UP POSITION:
Pull the pull pin knobs to disengage the LAT bars
from the tower cross arm and rotate the LAT bars down until they rest
on the rail.
ASSEMBLY
Содержание ELEVATE ENCOMPASS
Страница 1: ...ELEVATE ENCOMPASS TM OWNER S GUIDE...
