User’s Manual
6-11
PORTÉGÉ/TECRA R700 Series
Supervisor Password
If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password. To set a Supervisor Password,
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe
This utility lets you do the following:
■
Set, delete or change the Supervisor Password.
■
Specify restrictions for general users.
Starting the computer by password
If you have already registered a password, there are several ways to start
the computer:
■
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint System
Boot Authentication. If you would not like to swipe your finger or cannot
authenticate the fingerprint for some reasons, push the
BACK SPACE
key to skip the fingerprint authentication screen. You can try to swipe
the fingerprint up to five times. If you failed fingerprint authentication
five times, you must enter the password manually to start the computer.
■
Enter the password manually.
To enter a password manually, follow the steps as detailed below:
1. Turn on the power as described in chapter 1, Getting Started. The
following message will appear in the screen:
S
Password=
2. Enter the Password.
3. Press
ENTER
.
Power-up modes
The computer has three different power-up modes as follows:
The password is necessary only if the computer was turned off in Shut
Down Mode or Hibernation Mode.
It is not needed in Sleep Mode and Restart.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
