5
If the separate receiver unit is installed on the ceiling, use the provided ceiling mounting
bracket for installation.
1. Insert a screwdriver or similar tool into the notch
at the bottom to remove the receiver nameplate.
2. Cut a section out of the ceiling along the provided
paper pattern (95 x 51 mm).
3. Pass the wire through the provided mounting
bracket and insert the bracket into the installation
hole. (Fig. D)
Fig.D
4. Use bracket parts (A) and (B) to securely grip the
ceiling material. (Fig. E)
Fig.E
5. Connect the receiver wire (2-core) to the wire
from the indoor unit. (Refer to “Wiring the
Receiver Unit.”) Check the terminal number on
the indoor unit before wiring the receiver unit and
be sure not to wire incorrectly. (The unit will be
damaged if high voltage, such as 200 VAC, is
applied.)
6. Adjust the provided spacers so that they are sev-
eral millimeters larger than the thickness of the
ceiling material. Pass the 2 supplied screws (M4 x
40) through the spacers and tighten them enough
to hold the receiver unit in place.
7. Return parts (A) and (B) through the gap between
the ceiling and receiver unit so that they are con-
tained in the openings. Then tighten the screws.
Do not tighten the screws excessively. This may
result in damage or deformation of the case.
Tighten to the point where the receiver unit can
be moved slightly by hand. (Fig. F)
Fig.F
8. Reattach the nameplate.
Part (A)
Part (B)
EN-Book.book Page 5 Monday, June 14, 2004 8:14 PM
Heronhill - for all your Toshiba requirements
Tel: 01823 665660 www.heronhill.co.uk Fax: 01823 665807
