8
• The room temperature sensors are equipped in the indoor unit and the wireless remote controller.
One of two sensors works.
• The room temperature sensor is set to the indoor unit side at the shipment from the factory.
To select the sensor in the remote controller, push the SENSOR button (Right figure) inside of the
remote controller cover and check “Main sensor” disappears from LCD.
• When the multiple sensors are installed in the same room, an address can be set to prevent cross
communication.
• When replacing the battery and pushing SET button, the address of the remote controller becomes
[ALL] and the sensor is enabled to receive signal regardless of setting of address switch of the opera-
tion section.
• For selecting of the remote controller address, refer to Owner’s Manual.
• Change the address of the sensor by removing screws of P.C. board cover of the sensor unit. After
then, fix the cover with screws using a clamp.
How to set the room temperature sensor
NOTE :
If the room temperature data from the remote controller is not
transmitted to the unit for 10 minutes or more, the sensor at
indoor unit side is automatically selected even if the sensor at the
remote controller side is selected.
Fix the remote controller toward the unit as possible.
How to set the address switch
Display of
remote
controller
address
Address
Address
Address
• • • • •
Address
Address switch
position of
sensor
Address
switch of
sensor unit
can be set any
position.
• • • • •
Sensor
button
EN-Book.book Page 8 Monday, June 14, 2004 8:14 PM
Heronhill - for all your Toshiba requirements
Tel: 01823 665660 www.heronhill.co.uk Fax: 01823 665807
