4
When using exposed mounting for the receiver unit, install onto a wall where the receiver unit
can be attached.
1. Insert a flathead screwdriver or similar tool
into the groove on the bottom of the receiver
unit. Pry open with the screwdriver and
remove the lower case. (Fig. A).
Fig.A
2. In order to later pass the receiver wiring out
through the upper case (thin part at the top
center), use nippers or a similar tool to cut a
notch in the same size as the remote control-
ler cord (optional). (Fig. B)
Fig.B
3. Disconnect the wires that were connected to
the connector at the time of shipment.
4. Fasten the remote controller cord (optional) at
the position shown in Fig. C, using the pro-
vided clamper. Then connect the cord to the
receiver connector.
Fig.C
5. Shape the remote controller cord as shown in
Fig. C so that it fits at the top inside the
receiver unit, above the PCB. Then attach the
lower case. At this time, bend the head of the
clamp so that it faces sideways.
6. Remove the nameplate and use 2 wood
screws to attach the receiver unit.
7. Use the provided cord clips to fasten the
remote controller cord to the wall.
8. Reattach the nameplate.
Face plate
Notch where remote control-
ler cord passes through top
case
Clamp
Connector
Remote controller
cord (optional)
2–3mm
1
3
2
4
6
5
Clamp
Remote controller cord
(optional)
Wood
screws (2)
Receiver unit
EN-Book.book Page 4 Monday, June 14, 2004 8:14 PM
Heronhill - for all your Toshiba requirements
Tel: 01823 665660 www.heronhill.co.uk Fax: 01823 665807
